Valkyrie Riders Cruiser Club
April 23, 2025, 08:41:29 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
Ultimate Seats Link VRCC Store
Homepage : Photostash : JustPics : Shoptalk : Old Tech Archive : Classifieds : Contact Staff
News: If you're new to this message board, read THIS!
 
Inzane 17
Valkyrie Riders Cruiser Club > General > 1500 Tech Board > Separate electronic connections
Pages: [1]   Go Down
« previous next »
Send this topic Print
Author Topic: Separate electronic connections  (Read 162 times)
Jolton joe
Member
*****
Posts: 1

Lady lake,Fla
« on: April 19, 2025, 04:59:54 PM »
Trying to separate wiring connector on side stand switch.  Beyond having locks on housing, and being connected for 25 years cannot separate.
Any suggestions on how to separate without damaging.
Logged
99 Valkyrie st a standard
81 Honda CB900 Custom
08 Kawasaki Vulcan
h13man
Member
*****
Posts: 1711


To everything there is an exception.

Indiana NW Central Flatlands
« Reply #1 on: April 20, 2025, 05:56:20 AM »
Drown the connection with WD40 and carefully move around and let it soak etc. I would be sure to clean off excess with air if available afterwards or electronic cleaner. Maybe a little touch die electric grease going back together. A Honda OEM manual/wiring schematic can be helpful just in case.
Logged
Jims99
Member
*****
Posts: 799


Ormond Beach Fl.
« Reply #2 on: April 20, 2025, 06:09:50 AM »
I agree with the wd40. Picks up a lot of dirt and water down there. Probably just years of rode grime stuck inside.
Logged
The light at the end of the tunnel, is a train.
99 tourer
00 interstate
97 standard
91 wing
78 trail 70
Pages: [1]   Go Up
Send this topic Print
« previous next »
Jump to:  

Theme by Crip Powered by SMF 1.1.20 | SMF © 2013, Simple Machines MySQL | PHP | XHTML | CSS